PRACTICAL

Can You Drill or Cut a Magnet? Why the Answer Is Almost Always No | YUECI KEJI

Every workshop eventually asks this. The short answer is that sintered magnets are shaped before they are sintered, or ground afterwards, and never drilled or cut like metal.

Can you drill or cut a magnet? For sintered NdFeB, ferrite, SmCo and alnico, the answer is no, and the reasons are physical rather than commercial. These materials are pressed as powder and sintered into a hard, brittle solid. Anything you do to them after sintering has to be grinding, slicing with an abrasive wheel, or spark erosion, and a twist drill is the wrong tool in every case.

What happens if you drill a sintered magnet

Three things, all bad. The material cracks, because it has essentially no ductility to absorb the twist of a drill. The drill itself is destroyed, because sintered magnet material is harder than high-speed steel and abrasive enough to wear carbide quickly. And with NdFeB specifically, the swarf is a hazard: fine NdFeB dust is combustible, and it reacts with water to release hydrogen, so wet drilling a neodymium magnet can produce heat and gas in a confined space.

Why the shapes are made before sintering

The press is where a sintered magnet gets its shape. Powder is compacted in a die that already contains the hole, the step, the countersink or the profile, and the part comes out of sintering close to final form. This is why countersunk holes, center holes and odd profiles are standard catalogue items rather than special operations: the die makes them, and the die is the expensive part of a custom project.

Grinding: the only routine finishing

After sintering, parts are ground to final dimensions on diamond or cubic-boron-nitride wheels. Grinding removes material slowly and coolantly, holds tolerances around plus or minus one percent as standard and much tighter on request, and can flatten faces, thin a disc or true up a ring. What grinding cannot easily do is make a hole in a solid part, cut a notch, or produce an internal corner. The machining and grinding article covers the process in detail.

When slicing is possible

Thin slicing with a diamond wire saw or wire EDM is possible on some geometries, usually to make thin discs or rings from a thicker block. It is slow, it wastes material, and it is only economic for small quantities of hard-to-press shapes. For volume parts, pressing to shape remains far cheaper than slicing afterwards.

What to do instead

  • Order to size. If the drawing needs a hole, send the drawing. A pressed countersunk or center hole is a standard feature.
  • Use stock blanks. Unmagnetized block blanks can be machined with conventional methods before magnetizing, at the cost of tool wear and time.
  • Bond, do not cut. Assemblies are built from parts glued into steel cups and plates, which is how a pot magnet gets its hole without the magnet itself being drilled.
  • Consider bonded or flexible material. Rubber and bonded magnets can be cut with scissors or a blade, at the cost of most of their strength.

Frequently asked questions

Can I cut a magnet with a hacksaw?Technically you can remove material, and you will ruin the saw, crack the magnet, and produce hazardous swarf. It is not a useful operation.

What about grinding a magnet down to size?That works and is the standard finishing process, but it needs the right wheel, coolant and fixturing. Send it to a supplier rather than improvising on a bench grinder.

Is NdFeB dust really dangerous?Fine NdFeB swarf is combustible and reacts with moisture to release hydrogen, and it is abrasive enough to damage lungs if inhaled. Any cutting or grinding should be done wet, with extraction, by someone equipped for it.

Can alnico be drilled?Alnico is cast and is also hard and brittle, though slightly more forgiving than sintered ferrite or NdFeB. It is normally ground rather than drilled, and holes are cast in where the volume justifies a casting pattern.

Need a hole, a notch or a profile? Send the drawing and we will confirm what the press and the grinder can produce.