Sintered NdFeB is too hard and brittle to turn, so every dimension a buyer receives is produced by grinding, slicing or cutting. The method chosen decides both the tolerance and the risk of chipping.
Why magnets are ground, not turned
NdFeB is hard and brittle. A turning tool would tear the surface and chip the edges, so the material is removed by bonded or plated abrasive processes instead — grinding, sawing and slicing.
Multi-wire sawing and slicing
Thin discs and blocks are cut from a larger blank with a multi-wire saw carrying an abrasive slurry or a fixed diamond wire. YUECI KEJI holds utility-model patents on a multi-wire cutting machine for magnet production and on adhesive positioning aids for multi-wire cutting, plus a slicing machine for magnetic material.
Surface grinding and precision grinding
Faces and outer profiles are ground to the drawing, with cylindrical parts finished on automated grinding equipment. The company holds an invention patent on automatic grinding of cylindrical NdFeB parts and a utility-model patent on surface precision-grinding equipment, along with the fixtures that hold brittle parts steady.
Chamfering, drilling and finishing
Edges are chamfered to remove the brittle corners that would otherwise chip in service, and holes are produced where the assembly needs a fastener. YUECI KEJI's patent list covers multi-size chamfering machines, magnet cutting devices and grinding-machine fixtures.
What tolerance to expect
Dimensional tolerances are confirmed against the approved drawing and depend on part size, geometry and finishing process. Please identify critical dimensions when requesting a quotation. Chipping risk rises as parts get thinner, so packing and handling matter as much as the machining itself.
How machining choice shows up in service
A magnet that chips in assembly was either under-chamfered or badly handled; one that binds in a press-fit bore was ground to the nominal rather than to the tolerance band. Both are machining-stage outcomes, and both are visible to the buyer long before the magnetic performance is.
Balancing tolerance against cost
Tighter tolerance means slower feeds, more in-process measurement and higher scrap. Specify the tight band only where the assembly genuinely needs it, and let the supplier hold a standard band elsewhere.
Frequently asked questions
Can you hold ±0.05 mm on thickness? Yes, on ground faces, where the drawing calls for it — typical for sensor and voice-coil stacks.
Why are magnets chamfered? Sharp edges chip in handling and assembly. A small chamfer removes the brittle corner and makes the part safer to handle and easier to plate evenly.
Is there a minimum thickness you can slice? There is a practical floor set by the wire and the part's fragility. Send the target thickness and we will confirm feasibility.
How do you stop thin parts chipping? Support fixtures, controlled feed and coated, separated packing. Handling discipline is part of the specification on thin parts.
If your project needs a specific grade, geometry or magnetic result, Request a quote and share the drawing or the duty conditions.