Magnetic field heat treatment applies a controlled magnetic field while the magnet is being heat-treated. The field nudges the microstructure as it develops, and the result is a magnet with higher coercivity and better thermal stability.
The idea in one sentence
If a magnetic field is present while the microstructural phases that control coercivity are forming, those phases develop in a preferred orientation. The finished magnet then resists demagnetisation better than one heat-treated without the field.
What it changes
The treatment targets intrinsic coercivity and the temperature coefficient — the two properties that decide whether a magnet keeps its output in hot duty. That is why the process is associated with high-performance and high-temperature grades rather than with commodity magnets.
How it sits in the process chain
The field is applied during or around the post-sintering heat-treatment cycle, using dedicated fixture equipment. YUECI KEJI holds a utility-model patent on a magnetic-field heat-treatment device for high-performance magnet steel, alongside related patents on low-temperature-coefficient material preparation and on diluent mixing for grain-boundary diffusion.
When it is worth specifying
When the duty temperature is close to the limit of a conventional grade and a larger magnet is not an option. As with diffusion, a supplier should only recommend it where the duty actually demands it.
How to evaluate the claim
Ask for the measured coercivity and temperature coefficient on the treated grade, and compare them against the untreated version in the same family. The difference is the whole value of the process, and it is measurable.
Where it does not help
If the part runs at ambient temperature with margin, field heat treatment adds cost without changing anything the design will notice. It is a targeted process for a specific problem, not a general upgrade.
Frequently asked questions
Is field heat treatment the same as grain-boundary diffusion? No. Diffusion moves heavy rare-earth elements to the grain boundaries; field heat treatment acts on the microstructure during the thermal cycle. They can be combined.
Does it raise energy product? Its main effect is on coercivity and thermal stability rather than on energy product, which is set largely by composition and orientation.
How would I see the benefit in a datasheet? As a higher intrinsic coercivity figure or a flatter temperature coefficient for the same grade family.
Is it available on standard grades? It is used where the duty justifies it. Send the operating conditions and we will tell you whether the step is warranted.
If your project needs a specific grade, geometry or magnetic result, Request a quote and share the drawing or the duty conditions.