Magnet pricing looks opaque until you separate the seven things that actually drive it. Once separated, the pattern becomes predictable, and a quotation that is dramatically cheaper than the rest stops being attractive and starts being a question.
1. Feedstock, and its volatility
The dominant variable cost is the rare-earth feedstock: neodymium and praseodymium for NdFeB, samarium and cobalt for SmCo, and dysprosium or terbium for the higher temperature classes. These are concentrated global commodities whose prices move with policy and capacity announcements, and a magnet grade that contains a heavy rare earth is exposed to that price more than a base grade. This is why quotations carry a validity period, and why a responsible supplier states it.
2. Grade and heavy rare-earth content
Within NdFeB, a higher number means a higher energy product and usually a higher price. The suffix matters more: an SH or EH grade contains more heavy rare earth, or uses grain boundary diffusion to concentrate it, and both cost more than a base grade of the same number. If your application does not need the class, the class is money spent on a risk you do not have.
3. Geometry and volume
Simple pressed shapes in standard sizes are the cheapest, because the tooling is amortized across a large production. Unusual geometries, thin sections, tight radii and multipole magnetization fixtures all add tooling cost that has to be recovered over the order volume. A small first order of a complex part carries a high unit price that falls as the volume grows.
4. Tolerance
The standard tolerance for sintered parts is around plus or minus one percent. Tighter tolerances mean more grinding, more scrap and more inspection, and the price rises accordingly. Specify the tightest tolerance the function needs, not the tightest the drawing software can express.
5. Coating
Nickel-copper-nickel is the baseline. Zinc is comparable. Epoxy costs more and adds a process step. Gold, Parylene and specialty coatings cost substantially more and exist for reasons that are usually about the environment rather than about the magnet.
6. Tooling and setup
A custom pressed part needs a die, and a multipole part needs a magnetizing fixture. Both are one-off costs that are either amortized into the unit price or charged separately, and both are worth asking about explicitly, because a supplier who hides them in the unit price cannot reduce them when the volume grows.
7. Inspection level
Sampling inspection is the default. Full dimensional inspection, per-part flux measurement and per-lot magnetic records all cost more, and all are worth it when the application is safety-related or when the parts feed an automated line. Ask which level the quotation assumes.
Reading a quotation properly
When two quotations differ by a third, the difference is almost never margin. It is grade versus class, tolerance, coating thickness, inspection level, tooling treatment or price validity. Compare line by line, ask what each assumption was, and re-quote the outliers on the same basis before deciding. The supplier selection guide covers the wider evaluation.
Frequently asked questions
Why did the price change after the sample?Because the sample revealed a tolerance, coating or fixture requirement that the first quotation had not accounted for. It is a sign of a supplier doing the analysis, not of a bait and switch.
Is a higher grade always better value?No. A higher grade you do not need is a cost with no benefit, and a lower grade with the right temperature class often outperforms it in service.
How can I reduce cost without changing performance?Relax tolerances to what the function needs, standardize on a shape that amortizes tooling, and review the inspection level. All three are free performance.
Do prices fall with volume?Yes, mainly through tooling amortization and sintering batch efficiency. Ask for the volume breaks explicitly.
Comparing quotations? Send them over and we will tell you which lines are actually different.