APPLICATION

Magnets for Bicycles: E-Bike Hub Motors, Cadence and Speed Sensors | YUECI KEJI

The bicycle is the oldest magnet application in transport and, thanks to e-bikes, one of the fastest growing.

Bicycles have carried magnets for over a century, in dynamos and lights, and the arrival of the e-bike has turned a minor application into a substantial one. The magnets now in a bicycle divide into four groups, and each has a different specification logic.

E-bike hub motors

The motor in a hub-drive e-bike is either a geared high-speed motor or a direct-drive low-speed motor, and both use radially magnetized arcs in the rotor. Geared motors are small and run at high speed with modest torque, so a high remanence grade in a compact arc is the answer. Direct-drive motors are large, run slowly, produce high torque and get genuinely hot, because the rider's power is going through a stator with limited cooling. Direct-drive hubs are H and SH class territory, and they are one of the few consumer applications where the magnet runs near its thermal limit.

Pedal-assist cadence sensors

An e-bike decides when to help from a cadence sensor or a torque sensor. Cadence sensors read a magnetized ring or a small disc on the crank, counting revolutions to detect that the rider is pedaling. The requirement is a clean pulse train and a consistent air gap, so dimensional control matters more than grade. Torque sensors measure strain and use no magnet at all, though some combine both.

Speed sensors and lighting

Wheel speed sensors read a small magnet on a spoke passing a sensor on the fork, and the same principle drives cycle computers. Bottle dynamos, the friction generators that still power some lights, contain a small ferrite magnet, and hub dynamos use a multipole magnet ring inside the hub. These are low-power positions where cost and consistency dominate.

Braking and other positions

Some e-bikes use eddy-current braking, where a magnet array passing a conductive disc or drum provides a contactless retardation that is kind to rims and pads. Magnetic quick-release levers, magnetic pannier attachments and magnetic tool mounts round out the modern list. None of these are demanding magnetically; all of them are demanding in consistency and corrosion resistance.

Heat, water and vibration

Three environmental factors decide the specification. Heat, in the direct-drive hub motor, which is the one position where the temperature class genuinely matters. Water, everywhere, because a bicycle lives outdoors and gets washed: coating choice and sealing dominate the reliability discussion. Vibration, because a bicycle frame transmits every road imperfection to the magnet assembly, so bonding and edge condition matter.

What to specify

For a hub motor, send the rotor drawing, the continuous power and the measured hub temperature at rated assist. For a sensor, send the air gap and the sensor's operating range. For a dynamo, send the output target and the hub dimensions. The drone motor magnet range covers the same outrunner arc geometry, and the motor grade guide covers the temperature logic.

Frequently asked questions

Why do direct-drive hubs get so hot?Because the rider's power is converted through a large, slow, poorly cooled stator. The magnet sits close to the windings and sees the temperature.

Can a hub motor be re-magnetized?In principle, with the rotor stripped and the right fixture, but the cost usually exceeds the motor's value and the result needs re-verification.

Does a cadence sensor magnet need to be strong?No. It needs to be consistent and correctly positioned. A stronger magnet does not make the sensor more accurate and can saturate it.

What coating survives a wet winter?Epoxy over nickel-copper-nickel, with the assembly sealed where possible. For hub motor internals, the sealing is done by the motor housing rather than by the magnet.

Developing an e-bike motor or sensor position? Send the drawings and the measured temperatures and we will match the class to the duty.