APPLICATION

Magnets for Microwave Ovens: Magnetrons, Turntables and Door Switches | YUECI KEJI

The microwave oven contains one of the highest-volume ferrite magnet positions in the world, sitting a few centimetres from the hottest part of the appliance.

The microwave oven is a good example of an appliance where the magnet count is low but the volumes are enormous, and where one of the positions sits closer to extreme heat than almost anywhere else in domestic engineering. Three positions matter: the magnetron, the turntable or stirrer motor, and the door safety circuit.

The magnetron: the volume position

The magnetron, the vacuum tube that generates the microwaves, needs a static magnetic field along the axis of its electron interaction space. That field is provided by a ring magnet, almost always ferrite, held in an aluminum or steel frame around the tube. The ring is magnetized axially, through its thickness, and its dimensions are set by the tube's design rather than by magnetic optimization. Consumer magnetrons use ferrite because the field required is large in volume rather than high in strength, the temperature is high, and the parts are made by the tens of millions.

Why ferrite and not NdFeB

Three reasons, and they are the same three that decide most appliance positions. Cost: a large ferrite ring costs a fraction of the equivalent NdFeB part. Temperature: the magnetron runs hot, and ferrite's temperature ceiling is far above base NdFeB's. Corrosion: the position sees heat, some humidity during cooking, and no maintenance, and ferrite needs no plating to survive it. NdFeB appears in some industrial and high-power magnetron designs where the field has to be concentrated in a smaller volume, but the consumer oven is ferrite territory.

The turntable and stirrer motors

The turntable motor is a small synchronous motor with a ferrite or low-grade NdFeB ring or arc magnet, chosen for cost, quietness and reliability. The stirrer, where fitted, uses a similar small motor. These are cool positions with modest duty, and the magnetic specification is the least demanding in the appliance.

The door safety circuit

The door uses at least one reed switch, activated by a magnet in the latch, as part of a safety interlock that cuts power to the magnetron when the door opens. Some designs use two or three switches in series for redundancy. The magnet is small, usually a disc or block, and the position is specified for reliability: the switch must make and break cleanly through years of thermal cycling, humidity and vibration. A chipped or weak magnet here is a safety issue, not a performance one.

What to specify

For a magnetron ring, send the tube drawing and the frame design, and specify the field or flux the tube requires rather than a grade. For a motor magnet, send the rotor drawing and the duty. For a door switch magnet, send the switch's operating distance and the mounting stack-up. The ferrite ring range covers the stocked geometries.

Frequently asked questions

Is the magnetron magnet dangerous?It is a strong static field contained within the tube's frame, and it is not accessible in normal use. It does not affect the food or the cooking.

Can a microwave oven magnet be replaced?The magnetron is a serviceable part in some designs, but the magnet is part of the tube assembly and is replaced with it rather than separately.

Why is the turntable motor so quiet?It is a small synchronous motor running at low speed, with a ferrite magnet chosen partly for smoothness of rotation rather than strength.

Do magnetron rings need coating?Normally not. They ship as-pressed or painted, because ferrite does not corrode and the frame provides mechanical protection.

Developing an appliance position like these? Send the drawings and the local temperatures and we will recommend the material route.