Guides

Zinc vs Nickel Coating on Magnets: Cost, Corrosion and Appearance | YUECI KEJI

Zinc and nickel are both standard NdFeB coatings, and the choice between them is usually the first cost-versus-corrosion decision in a specification.

Zinc and nickel are both standard NdFeB coatings, and the choice between them is usually the first cost-versus-corrosion decision in a specification.

What each coating is

Zinc plating on NdFeB is typically 5–10 μm, applied as white, blue, coloured or black zinc, and it is the cheapest of the standard coatings. Ni-Cu-Ni plating runs 10–20 μm with a nickel strike, a copper layer and a nickel cap, and it is the most common finish in the industry.

Both are barrier coatings: they keep moisture off a magnet surface that corrodes quickly without them.

Corrosion performance

Per the YUECI KEJI surface-treatment datasheet, Ni-Cu-Ni passes a 96-hour PCT and 48–72 hours of neutral salt spray. Zinc is thinner and less expensive, with correspondingly less corrosion margin — it suits indoor and dry duty rather than marine or outdoor exposure.

Neither coating survives scratching. Both rely on the barrier being intact, which is why handling and edge coverage matter as much as the coating choice.

Appearance and cost

Zinc is the cost-first finish: cheapest per part, fastest to apply, available in several colours. Nickel is the appearance finish: bright, uniform and the colour most buyers expect from a machined magnet component. On high-volume indoor programs the zinc saving compounds; on visible or export-grade parts nickel is the norm.

Where each wins

  • Zinc — high-volume indoor duty, cost-first programs, parts that live inside an assembly.
  • Nickel — general-purpose export duty, visible parts, anything that has to look like a finished component.
  • Epoxy — outdoor, marine and handled duty, where both zinc and nickel run out of margin.

The decision

Start from the environment. Dry and indoor points to zinc; general duty points to nickel; wet, salty or handled points to epoxy or nickel-plus-epoxy. Then check the budget — the coating is a small part of the piece price but a large part of the service life.

Frequently asked questions

Is zinc coating much cheaper than nickel? Yes — zinc is the cheapest standard NdFeB coating, and on high-volume programs the saving per part compounds.

Can zinc-coated magnets be used outdoors? Not recommended. Zinc is thinner with less corrosion margin; outdoor and marine duty calls for epoxy or nickel-plus-epoxy.

Does zinc come in colours? Yes — white, blue, coloured and black zinc are all standard options.

Which coating should I specify as a default? Ni-Cu-Ni, if you are unsure. It is the industry default because it balances cost, corrosion performance and appearance.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.