An arc magnet and a ring magnet can build the same rotor. The difference is whether the annulus arrives whole or in pieces.
What each shape is
A ring is a full annulus — a complete circle of magnetised material with a through-bore. An arc is a segment of that circle, designed to nest with its neighbours into the same ring. Both mount on shafts; both can be magnetized radially or multipole.
The ring arrives as one part. The arc set arrives as matched pieces that have to be assembled — and that difference drives most of the engineering.
Material efficiency and pole count
A full ring is one magnetizing operation and one grinding setup, which makes it efficient for even pole counts and simple patterns. Arcs shine on odd pole counts and on designs where the pole pattern has to be tuned: each segment is magnetized separately, and the pattern is set by the number of segments rather than by a complex fixture.
Arcs also waste less material when the ring has features a full annulus cannot carry — skew steps, bonding gaps, sensor pockets.
Assembly and balance
A ring is a single part: drop it on the shaft and retain it. An arc set has to be assembled piece by piece, which adds labour and introduces balance and gap-uniformity requirements. Matched sets are supplied ground, magnetized and inspected together so the pole pattern closes correctly — but the assembly cost is real and belongs in the comparison.
Where each wins
- Ring wins when the pole count is even, the pattern is simple and assembly labour matters.
- Arc wins when the pole count is odd, the pattern is complex, or the ring has to carry features a full annulus cannot.
The decision
Start from the pole count and the pattern. Even and simple points to a ring; odd or complex points to arcs. Then check the assembly cost: an arc set that saves material but doubles build labour is not a saving.
Frequently asked questions
Is a ring always stronger than arcs of the same total angle? Not necessarily — the total magnetised material is what matters. A ring avoids the assembly gaps between segments, so it can be slightly more efficient for the same volume.
Can arc sets be supplied matched? Yes. Segments for one rotor are ground, magnetized and inspected as a set so the pole pattern closes correctly around the ring.
Why would I choose arcs over a ring? Odd pole counts, complex patterns, or ring features a full annulus cannot carry — skew steps, bonding gaps, sensor pockets.
Do arcs cost more to assemble? Yes. An arc set adds piece-by-piece assembly labour and gap-uniformity requirements; matched sets reduce the risk but not the labour.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.