Diametric and radial magnetization both put poles around a cylindrical magnet, but they put them in different places — and that difference decides which sensors and circuits they suit.
What diametric magnetization is
A diametrically magnetized cylinder has its two poles on opposite sides of the cylindrical surface, on a line through the diameter. The field leaves one side of the cylinder and returns to the other, which makes it the natural choice for side-acting sensing — a Hall sensor reading past the curved surface, or a reed switch triggered as the magnet sweeps by.
What radial magnetization is
A radially magnetized cylinder has poles distributed around the circumference — one polarity all around, the other on the axis or the opposite face. It is the standard for rotary machines: motor rotors, couplings and multipole rings, where the field has to act outward from the rotor surface all the way around.
A radially magnetized ring can also be multipole, with the pole pattern repeating around the circumference — the basis of encoder and rotor duty.
How they differ in practice
- Diametric — two poles, one diameter apart; suits side-acting sensors and reed triggers.
- Radial — poles around the circumference; suits rotors, couplings and multipole rings.
- Axial — poles on the two flat faces; the default for discs, blocks and holding work.
Why the direction is a specification item
Magnetization is set by the magnetising fixture, not by the geometry. The same cylinder can be supplied axial, diametric or radial, and each needs its own fixture — which is why the direction has to be on the drawing, with a tolerance on the pole position where it matters.
Getting the direction wrong is not a small error: a diametric part in a radial circuit delivers a fraction of its potential force, and the mistake is invisible until the assembly is tested.
What to send with the enquiry
Send the sensing or torque direction — which face or which way around the circumference the field has to act — and the pole count if the part is multipole. The direction is then confirmed from the duty rather than assumed from the shape.
Frequently asked questions
What is the difference between diametric and radial? Diametric puts two poles on opposite sides of the cylinder surface; radial distributes poles around the whole circumference. Different circuits, different fixtures.
Which is used in motors? Radial, usually multipole — the field has to act outward from the rotor surface all the way around.
Can any shape be magnetized in any direction? Within reason, yes — magnetization is set by the fixture, not the geometry. Each direction needs its own fixture, which is why it must be specified.
What happens if the direction is wrong? The part delivers a fraction of its potential force in the circuit, and the error is invisible until assembly. It is one of the most common magnet specification mistakes.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.