Alnico and NdFeB answer different questions. NdFeB answers 'how much force in the smallest space'; alnico answers 'how little the field drifts as conditions change'.
The fundamental trade
NdFeB is the strongest commercial permanent magnet: 39–60 MGOe across the standard range, in a compact part that needs coating. Alnico delivers far less energy per unit volume — parts are physically larger for the same force — but its field barely moves as temperature swings.
The choice is therefore rarely about strength. It is about whether drift or size is the binding constraint.
Temperature behaviour
Alnico's very low reversible temperature coefficient keeps its output predictable from cryogenic temperatures up to several hundred degrees Celsius. NdFeB's standard grades are rated to 80℃ and lose reversible flux as they heat; high-temperature suffixes push that to 120–230℃ but at a cost and, for the Dy-bearing grades, under export licence.
In a meter or an instrument, drift is the enemy. In a motor, size is the enemy. That single distinction decides most alnico-versus-NdFeB choices.
Mechanical and practical differences
Alnico is less brittle than ferrite and machines well after sintering — drilling, grinding and threading are routine. NdFeB is hard, brittle and needs a coating to survive corrosion. Alnico is often supplied bare; NdFeB never should be.
Alnico is also the cheaper material per kilogram, which partly offsets the larger part — though not usually the whole difference.
Where each wins
- Alnico wins in sensors, meters and instruments where drift cannot be tolerated, and in very high-temperature duty.
- NdFeB wins wherever force density matters — actuators, compact motors, sensors with tight envelopes, anything handheld.
The decision
Ask what the application cannot tolerate. If it is field drift, alnico. If it is size or mass, NdFeB. If it is both, a high-temperature NdFeB grade with a designed-in margin is often the compromise — but check the drift budget first.
Frequently asked questions
Is alnico stronger than neodymium? No — NdFeB carries several times alnico's energy product. Alnico parts are physically larger for the same force.
Why is alnico used in meters? Its very low temperature coefficient means the field barely drifts as temperature changes, which is exactly what a precision instrument cannot tolerate.
Does alnico need coating? Usually not. Alnico resists corrosion reasonably well and is often supplied bare, or with a light epoxy or Ni-Cu-Ni coat where the environment calls for it.
Can alnico be machined after sintering? Yes — it machines well after sintering, so drilling, grinding and threading are routine.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.