Guides

SmCo vs Ferrite Magnet: High Temperature Against Low Cost | YUECI KEJI

SmCo and ferrite sit at opposite ends of the rare-earth decision: one is the high-temperature specialist under export control, the other is the cheapest material in the catalogue.

SmCo and ferrite sit at opposite ends of the rare-earth decision: one is the high-temperature specialist under export control, the other is the cheapest material in the catalogue.

The material comparison

Ferrite is the lowest-cost permanent magnet family: it needs no plating, tolerates high temperatures and resists corrosion intrinsically, at roughly a quarter of NdFeB's energy per unit volume. SmCo is a rare-earth magnet — second only to NdFeB in energy product — that keeps its field at markedly higher temperatures and resists oxidation without heavy plating.

Both handle environments that bare NdFeB cannot. They differ in force, price and paperwork.

Temperature and corrosion

Ferrite tolerates temperatures well above the standard NdFeB range and resists corrosion intrinsically. SmCo goes further on both counts: it holds field at temperatures where ferrite's output has fallen away, and it survives oxidation with a simple passivation.

For genuinely hot duty — turbine instrumentation, downhole sensing, hot rotors — SmCo is the material that survives when everything else has demagnetised.

Cost and licensing

Ferrite is the cheapest material in the catalogue. SmCo carries a high material price and sits under China's export-control list, so every shipment needs a licence and an end-use review. That combination confines SmCo to duty that genuinely requires it.

Where each wins

  • Ferrite wins on cost-first, high-volume duty where the envelope is generous — speakers, appliance motors, separators, catches.
  • SmCo wins on extreme duty where the temperature or corrosion environment defeats every other option, and the licence is acceptable.

The middle ground

Before reaching for SmCo, check the high-temperature NdFeB grades. The SH series is rated to 150℃ and the UH series to 180℃, at a lower cost than SmCo — though still under export control. SmCo earns its place above those grades, or where corrosion resistance without plating matters as much as temperature.

Frequently asked questions

Is SmCo much stronger than ferrite? Yes — SmCo is a rare-earth magnet with energy product second only to NdFeB, several times ferrite's.

Is SmCo export controlled? Yes. Samarium cobalt is controlled under China's export-control list; YUECI KEJI handles licensing and end-use review at order confirmation.

Should I try high-temperature NdFeB first? Usually yes. SH and UH grades cover most hot duty at a lower cost than SmCo, though they also carry export licences.

Which is better against corrosion? SmCo, which survives oxidation with a simple passivation. Ferrite is intrinsically corrosion-resistant but brittle.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.