Guides

Sintered vs Cast Alnico: Choosing the Right Manufacturing Route | YUECI KEJI

Cast and sintered alnico make the same alloy by different routes, and the route decides what the part can be — its tolerances, its geometry and its price.

Cast and sintered alnico make the same alloy by different routes, and the route decides what the part can be — its tolerances, its geometry and its price.

What each route is

Cast alnico is poured into a mould and finished by grinding. It is the traditional route, and it delivers the best magnetic properties in the family — the highest energy product grades are cast.

Sintered alnico is pressed from powder and sintered. It gives tighter tolerances, more complex geometries and better mechanical strength, at some cost in magnetic output.

Tolerances and geometry

Sintered parts come out of the press close to final shape, so tolerances are tighter and features — holes, steps, thin sections — are practical. Cast parts need more grinding and are better suited to simpler geometries with generous allowances.

Both routes machine well after forming, so secondary operations are routine either way.

Mechanical and magnetic trade

Sintered alnico is mechanically stronger and less prone to the porosity and shrinkage features of casting, which suits small and intricate parts. Cast alnico reaches the higher energy grades, which suits larger parts where output matters.

For most instrument work the difference is invisible; for a large meter magnet the cast route's output can be decisive.

Cost and volume

Sintering suits volume: the press makes the same part repeatedly with little finishing. Casting suits larger parts and smaller runs, where the mould cost is amortised differently. Neither route is expensive in absolute terms — alnico is a low-cost material.

The decision

Small, intricate, volume parts point to sintering. Large parts where maximum output matters point to casting. When the geometry is simple and the volume modest, either route works and the choice comes down to tolerance and output.

Frequently asked questions

Which route gives better magnetic properties? Cast alnico — the highest energy-product grades in the family are cast. Sintering trades some output for tolerance and geometry.

Which gives tighter tolerances? Sintered. Parts come out of the press close to final shape, so less grinding is needed and features are practical.

Can both be machined after forming? Yes — alnico machines well after sintering or casting, so drilling, grinding and threading are routine on both routes.

Which is better for volume production? Sintering, because the press repeats the same part with minimal finishing. Casting suits larger parts and smaller runs.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.