Remanence and coercivity are the two numbers that define a permanent magnet's behaviour. One measures how much field it carries; the other measures how hard it is to remove.
What remanence is
Remanence (Br) is the flux density a magnet retains after the magnetising field is removed — how much field the part carries in the open circuit. It is measured in tesla or gauss, and across the YUECI KEJI NdFeB range it climbs from around 1.22 T at 38SH to 1.49–1.55 T at N58.
More remanence means more flux in the same geometry, which is why the energy-product grades are numbered by it.
What coercivity is
Coercivity is the reverse field needed to demagnetise the magnet. Intrinsic coercivity (Hcj) is the figure that matters: it measures resistance to demagnetisation, and it is what the temperature suffixes change. Standard grades hold at least 955 kA/m (12 kOe); the SH series reaches 1592 kA/m (20 kOe) and the UH series 1990 kA/m (25 kOe).
More coercivity means the magnet survives hotter duty and stronger opposing fields — at the cost of some remanence.
Why the trade exists
The two numbers move against each other. Raising coercivity — through heavy rare-earth additions — costs remanence and money. A 38SH part carries less flux than an N52 of the same size but survives 150℃ where the N52 would demagnetise.
This is why the grade choice is never just 'the strongest magnet': it is the strongest magnet that survives the duty.
Reading a datasheet
- Br — how much field you get. Higher is more force in the same envelope.
- Hcj — how hard it is to take away. Higher is more temperature and field margin.
- (BH)max — the energy product, which combines both into the working figure.
- The suffix — M, H, SH, UH, EH: the temperature class, set by the coercivity.
The practical rule
Choose remanence for the force budget and coercivity for the survival budget. Size the part on Br, then check that the Hcj of the chosen suffix covers the hot-spot temperature with margin. If it does not, the part will pass on the bench and fail in service.
Frequently asked questions
Which is more important, Br or Hcj? Both, for different budgets. Br sets the force you get; Hcj sets the conditions the magnet survives. Size on Br, then verify Hcj against the hot spot.
Why do high-temperature grades deliver less flux? Raising coercivity through heavy rare-earth additions costs remanence — the trade is built into the material.
What does the M, H, SH suffix change? The coercivity and therefore the temperature rating: M is 100℃, H is 120℃, SH is 150℃, UH is 180℃, EH is 200℃.
Can a magnet lose its remanence in service? Yes — if it is driven past its coercivity limit by temperature or an opposing field, the loss is irreversible. That is why the suffix matters.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.