Rare earth magnet recycling closes the loop on the most supply-constrained part of a magnet: the rare-earth content. Recovering neodymium and dysprosium from production scrap and end-of-life parts reduces both cost exposure and import dependence.
Why recycling matters for magnets specifically
The rare-earth fraction of an NdFeB magnet is the expensive, supply-constrained part of the recipe. Production itself generates scrap — grinding swarf, off-cuts, rejected blanks — and end-of-life products such as wind-turbine generators, hard-disk drives and motors concentrate the same material. Recovering it shortens the chain between mine and magnet.
The route from scrap to material
Collected NdFeB scrap is oxidised and then calcined at controlled temperature, which converts the metallic scrap into an oxide form that can re-enter separation and refining. The recovered oxide is then blended back into alloy preparation. YUECI KEJI holds a utility-model patent on an NdFeB scrap oxidising and calcining device, so this step is engineered in-house rather than sent out.
In-process recycling versus end-of-life recovery
In-process recycling is the easier case: the composition is known, the material is clean and it never leaves the site. End-of-life recovery is harder — magnets arrive inside assemblies, mixed with other materials and often corroded — so separation and sorting quality decides the economics.
What recycling does and does not fix
Recovery reduces the primary rare earth a plant needs and cuts the carbon cost of mining and refining. It does not by itself remove the need for new material, because demand keeps growing and recovered volumes are limited by collection rates. It is one lever, not a complete answer.
How this fits the wider supply picture
YUECI KEJI's technology programme also targets high-abundance rare-earth material — using more cerium and less of the scarcer elements — which reduces the same supply pressure from the other direction. The company's patent list includes cerium-alloy casting equipment and infiltration tooling for high-abundance cerium-iron-boron material.
What buyers can do
Buyers influence recovery rates more than they think. Ask suppliers what happens to production scrap, prefer suppliers who recover in-process material, and design assemblies so the magnet can be separated at end of life. Those three choices move more material than any single recycling plant.
Limits worth stating plainly
Recovery cannot outrun demand growth on its own, and end-of-life collection is slow because products stay in service for years. Recycling is a supply hedge and an environmental measure, not a substitute for responsible material use.
Frequently asked questions
Can recycled material match virgin quality? For in-process scrap with a known composition, yes — it re-enters alloy preparation at controlled purity. Mixed end-of-life feedstock needs more separation work and usually blends rather than replaces.
Do you buy back magnet scrap? Production scrap is handled internally. For external scrap streams, send the composition and volume and we will tell you whether it suits our recovery route.
Is recycled-content magnet cheaper? Not automatically. The benefit is supply security and reduced environmental impact rather than a lower unit price, and it depends on collection and separation costs.
What about dysprosium and terbium? Those are the scarcest and most valuable elements in hot-duty grades, so recovering them is the highest-value part of magnet recycling.
If your project needs a specific grade, geometry or magnetic result, Request a quote and share the drawing or the duty conditions.