A pot magnet is a disc magnet inside a steel cup. The cup roughly doubles the pull force — and changes the reach behaviour completely.
What the cup does
Flux leaves the magnet's working face, spreads through the steel cup and concentrates at its rim, then returns through the workpiece to the back of the cup. Because the return path is steel rather than air, far more of the magnet's flux does useful work — the same disc in a cup can roughly double its pull force.
The cup also shields and protects the magnet from impact and corrosion, which is why pot assemblies are the default for workshop, outdoor and retail duty.
The reach trade
The cup's advantage is contact. In direct contact the assembly pulls far harder than the bare disc; across a gap the field falls away quickly, because the steel return path needs the workpiece close. A bare disc, by contrast, keeps more of its field at a distance.
So the choice is not just about force — it is about whether the load touches.
Protection and mounting
A bare disc is a finished part: it can be bonded, captured or stacked, and its faces are available for flux work. A pot assembly is a mounting component: the cup carries a countersunk bore, a threaded stud or a plain base, and the magnet is fully enclosed. The fixing is part of the design.
Where each wins
- Pot wins for close-contact holding, mounting and outdoor duty — lighting, signage, retail fixtures, workshop holding.
- Disc wins when reach matters, when the faces must be exposed for flux work, or when the part is bonded or stacked into an assembly.
The decision
Ask whether the load touches the magnet. If it does, a pot assembly gives more force and more protection for the same magnet. If the load sits at a distance, or the faces have to be exposed, a bare disc is the right part.
Frequently asked questions
How much more force does a pot magnet give? It depends on the cup geometry, but the same disc in a cup can roughly double its pull force on a clean steel test block.
Does a pot magnet work across a gap? Poorly. The steel return path needs the workpiece close; across a gap the field falls away quickly. A bare disc holds more of its field at a distance.
Is a pot magnet more durable than a bare disc? Yes — the enclosed magnet is protected from impact and corrosion, which is why pot assemblies are the default for workshop and outdoor duty.
Which is cheaper? The bare disc, clearly — the cup adds material, machining and assembly. The pot earns its cost when the force and protection are needed.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.