Bare sintered NdFeB corrodes readily, which is why the coating is part of the product rather than an optional finish. The choice is a trade between cost, corrosion resistance and temperature capability.
Why NdFeB corrodes
Sintered NdFeB contains rare-earth elements that react readily with moisture, and the sintering process leaves a porous, multiphase microstructure with a large internal surface area. Uncoated parts rust, and the corrosion products expand and crack the part from inside.
The common finishes and what they buy
Ni-Cu-Ni is the default: good corrosion resistance, solderable, economical. Zinc is cheaper with moderate protection. Epoxy layers give heavy barrier protection and a non-reflective finish, at the cost of temperature headroom. Gold is used where conductivity or biocompatibility matters. Nickel-copper-nickel plus epoxy combines both barriers for humid or coastal duty.
Matching the finish to the environment
Indoor, dry duty is comfortable with Ni-Cu-Ni. Humid or coastal duty argues for NiCuNi plus epoxy. High temperature argues against thick organic layers. Where the environment is aggressive and the temperature is high, SmCo or ferrite may be the better material choice rather than a better coating.
Edges, holes and handling
Coatings are thinnest at edges and inside holes, which is where corrosion starts. Chamfered edges, clean hole geometry and careful handling in assembly all extend the life of the finish. A magnet that is scratched during installation has a failure site regardless of the coating specified.
Frequently asked questions
Can NdFeB be supplied uncoated? It can, but only for dry, protected, short-life duty. For anything else a coating is part of the specification.
Which coating is best for outdoor use? NiCuNi plus epoxy gives the heaviest barrier. For long outdoor life in aggressive conditions, SmCo is often the better material choice.
Does a coating affect pull force? Slightly, by adding a gap at the working face. The effect is small on a plated part and larger on thick epoxy builds.
How do I know the coating is intact? Thickness is verified per lot, and visual inspection covers coverage on edges and holes. Report any handling damage before assembly.
If your question is not covered here, Request a quote and our engineering team will answer it directly.