N52 and N52SH share almost the same remanence band and sit at opposite ends of the coercivity range. The choice between them is a pure temperature decision.
What the suffixes mean
Per the YUECI KEJI sintered NdFeB datasheet, N52 delivers 1.42–1.47 T remanence with an intrinsic coercivity of at least 955 kA/m (12 kOe) and a 49–54 MGOe energy product, rated to 80℃. The 52SH composition keeps the same 1.42–1.47 T remanence and 49–54 MGOe band but raises intrinsic coercivity to at least 1512 kA/m (19 kOe) and the recommended maximum operating temperature to 150℃.
The coercivity comes from a heavy rare-earth addition — and that addition is what puts the grade on China's export-control list.
What the extra coercivity buys
Coercivity is resistance to demagnetisation. A magnet working near its limit loses flux when the temperature rises or when a opposing field is applied; the SH composition survives both. The practical benefit is that the part holds its output in service instead of quietly weakening — which matters far more in a motor than on a bench.
The costs of the suffix
- Material cost — heavy rare-earth additions make SH powder materially more expensive per kilogram.
- Export control — the dysprosium content places the grade on China's export-control list, so each shipment needs a licence and an end-use review. That adds lead time and paperwork.
- Flux at cold — marginally lower room-temperature flux than the standard grade at the same geometry.
The decision rule
Decide on the hot-spot temperature, not the average. If the magnet sees 80℃ or less in the worst corner of its duty, standard N52 is the right grade. If it sees 120℃, look at the H series; 150℃, look at SH; above that, UH or EH. Choosing SH for a cool application pays for coercivity the circuit cannot use, plus a licence it does not need.
A common mistake
The common mistake is sizing the magnet at room temperature and assuming the flux holds. In a motor, a standard-grade magnet that reaches its limit early in a hot soak never recovers — the loss is irreversible. If there is any doubt about the hot spot, specify the suffix and design the circuit around the lower cold flux.
Frequently asked questions
Does N52SH lose flux compared with N52? Very little at room temperature — the remanence band is the same. The real trade is cost, licence and the coercivity margin you gain.
Is N52SH export controlled? Yes. The dysprosium addition places it on China's export-control list; YUECI KEJI handles licensing and end-use review at order confirmation.
When is SH the wrong choice? When the part runs cool. Below 80℃ the coercivity margin is unused, and you pay a material premium plus licensing for nothing.
What about N52H instead? The H series is rated to 120℃ — the middle rung between standard N52 and SH. It suits warm duty where 150℃ would be over-specification.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.