Guides

N35 vs N52 Magnet: Choosing Between the Economy and Top Grade | YUECI KEJI

N35 and N52 sit at opposite ends of the commercial sintered NdFeB range, and the choice between them is really a choice between buying material and buying envelope.

N35 and N52 sit at opposite ends of the commercial sintered NdFeB range, and the choice between them is really a choice between buying material and buying envelope.

The headline difference

Per the YUECI KEJI sintered NdFeB datasheet, N52 delivers a remanence of 1.42–1.47 T and a maximum energy product of 49–54 MGOe. N35 sits below the N42 band of 39–44 MGOe, with remanence below 1.28 T and the same intrinsic coercivity floor of at least 955 kA/m (12 kOe). In plain terms, N52 gives roughly a third more energy product than N35.

Both carry the same standard 80℃ maximum operating temperature. Neither is the answer to a hot application — that is what the M, H and SH suffixes are for.

What the extra grade buys

The extra flux buys envelope. A part designed on N35 and rebuilt on N52 shrinks — sometimes by a quarter of its volume for the same force — and in a space-constrained assembly that is worth more than the material saving. Conversely, where the envelope is already generous, the N35 part works and costs less per kilogram.

Cost and process behaviour

N35 is the easiest grade in the range to press and grind, which keeps yield high on thin sections, odd geometries and high-volume programs. N52 demands tighter process control: thin parts and extreme aspect ratios are more prone to chipping and to demagnetisation risk during handling. On a high-volume program that yield difference shows up in the piece price as much as the powder does.

Where each grade wins

  • N35 wins when the volume is high, the envelope is generous and the duty is low-force: craft and educational assemblies, latches, light holding, high-volume sensor targets.
  • N52 wins when the force target is fixed and the envelope is not: compact actuators, high-torque small motors, anything where a bigger magnet simply does not fit.

A practical decision path

Start from the force or field target and the available envelope. If an N35 part fits and meets the target, it is usually the right commercial answer. If it does not fit, step up through N42, N45, N48 and N50 before committing to N52 — in most designs the intermediate grades close the gap at a lower cost than the top grade. Reserve N52 for the cases where nothing else fits.

Frequently asked questions

Is N52 always stronger than N35? In energy product, yes — roughly a third more. In a real assembly the difference shows up as force only if the magnetic circuit can use it; a poorly designed circuit can waste the extra grade.

Does N52 cost much more than N35? Per kilogram, yes — the top grades carry a material premium and a process-cost penalty. Whether it costs more per part depends on how much smaller the N52 part can be.

Can I substitute N52 for N35 in an existing design? Mechanically yes if the geometry is unchanged, but the force will rise substantially, so check that the assembly, the retention and any nearby electronics tolerate the stronger field.

Do both grades have the same temperature rating? Yes — the standard compositions are both rated to 80℃. For hotter duty look at the M, H, SH, UH or EH suffixes instead.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.