The modern washing machine is a magnet-intensive appliance. The drum is turned by a direct-drive brushless motor that is essentially a ring of magnet arcs around a stator, the water is moved by a small drain pump motor, the door is held by an interlock that uses a reed switch and a magnet, and the drum's position and speed are read by sensors that also depend on magnets. The material split across those positions is a clean lesson in magnet economics.
The direct-drive motor: the big one
Older machines used a belt and a brushed motor. Modern machines use a direct-drive brushless motor bolted to the drum, with the rotor carrying a ring of magnet arcs. Cost-driven machines use ferrite arcs, which give a weaker field but tolerate the heat, cost a fraction as much and need no plating. Premium machines, where the motor has to be compact and efficient enough to meet energy labels, use NdFeB arcs. Either way the arcs are supplied as a matched set, because asymmetry in the ring shows up as vibration and noise.
Drain pump and valve motors
The drain pump is a small synchronous or DC motor with a ferrite or low-grade NdFeB ring or arc magnet, and the inlet valves are solenoids rather than permanent-magnet parts. These positions are chosen for cost and volume: the field required is small, the duty is intermittent, and the parts are made by the million.
Door interlock: the safety-critical one
The door lock is a reed switch and a magnet. The switch has to confirm the door is closed before the machine will start, and it has to keep confirming it through vibration, humidity and years of thermal cycling. The magnet is small, usually a disc or block in a base NdFeB grade, and its reliability is a safety matter rather than a performance one, which is why the position is specified conservatively and inspected carefully.
Drum position and balancing
Some machines read drum position with a Hall sensor and a magnetized ring or a small magnet on the drum, and use the reading to control the spin-up profile and detect an unbalanced load. Others detect imbalance mechanically. Where a sensor is used, the magnet's job is to deliver a clean pulse train, so dimensional consistency matters more than strength.
The environment decides the details
Three environmental factors shape the specification. Heat: a motor that runs for an hour at full load gets hot, so the temperature class has to cover the winding temperature rather than the ambient. Humidity: the drum cavity is wet, so coating choice matters, and ferrite's natural corrosion resistance is one reason it persists in wet positions. Vibration: an unbalanced load at spin speed shakes everything, so edge condition and bonding matter as much as the magnetic values.
What to specify
For a motor arc set, send the rotor drawing with the arc count, the air gap and the motor's continuous operating temperature. For an interlock magnet, send the switch's operating distance and the mounting stack-up. For a sensor ring, send the pole count and the reading the sensor needs. The ferrite motor magnet and NdFeB motor magnet ranges cover the two material routes.
Frequently asked questions
Why do budget machines use ferrite motors?Because the motor can be larger if it is cheaper, and ferrite tolerates the heat and moisture without plating. Energy-label machines need the compactness of NdFeB.
Can a direct-drive motor be re-magnetized?In principle, with the arcs removed from the rotor, but the fixtures and the measurement make it a specialist repair rather than a service operation.
What happens if the door interlock magnet fails?The machine will not start, or will stop mid-cycle. It is a fail-safe design, which is exactly why the magnet is specified conservatively.
Does the drum magnet affect clothes or watches?The rotor magnets are contained inside the motor housing and are not accessible in normal use. A watch left on top of a running machine is not at risk.
Developing an appliance motor or interlock? Send the position drawings and temperatures and we will recommend the material route.