The motor in a cordless drill or impact driver is an outrunner with radially magnetized arcs in the bell, running at high current, in a sealed housing, with almost no cooling. It is one of the hottest magnet duties in mainstream engineering, and it is the reason power tool motors specify temperature classes rather than peak grades.
The motor and its duty cycle
A tool motor is used in bursts. Full current under load heats the windings quickly, and the magnets sit close enough to feel it. A drill that stalls, or an impact driver delivering torque in bursts, pushes the rotor temperature well above what the same motor would see in continuous light duty. The magnet has to survive the worst burst, not the average, which is why H and SH classes are the default rather than an upgrade.
Why the class matters more than the number
The temptation is to specify the highest remanence available, and it is the wrong instinct. A top-grade magnet in a low temperature class loses flux in service, and the motor loses speed and torque in a way that looks like a battery problem. A slightly lower remanence in an H or SH class holds its field through the duty cycle and delivers consistent performance. The intrinsic coercivity article explains why the suffix, not the number, is the temperature rating.
Pulse demagnetization and fault conditions
Tool motors see current spikes that produce opposing fields inside the rotor, particularly at stall and at the start of an impact. Those spikes can push a magnet past the knee of its demagnetization curve, and the damage is permanent and invisible: the tool simply becomes weaker. A grade with enough coercivity survives the spike. This is the second reason tool motors specify class rather than peak strength.
Coating and the construction-site environment
The motor cavity in a tool is not a clean environment. It sees concrete dust, humidity, temperature swings and occasional impact. Nickel-copper-nickel is the standard coating, and epoxy is used where the cavity is wetter or where impact tolerance matters. Edge condition matters too, because a chip in a motor bell becomes a rotor imbalance and a bearing problem later.
Other magnet positions in a tool
- Electronic commutation: Hall sensors reading a small magnetized disc or a multipole ring on the shaft.
- LED work lights: a small holding magnet or a magnetic base in some designs.
- Battery packs and accessories: magnetic latches, bit holders and magnetic wristbands in the ecosystem.
- Fans: on the larger tools, a small cooling fan with ferrite or NdFeB magnets.
What to specify
Send the rotor drawing with the arc count, skew, air gap and the motor's continuous current. Ask for the magnet's local temperature to be measured on a prototype rather than estimated. Choose the class from that measurement with a margin, and let the remanence follow. The drone motor magnet range covers the same outrunner arc geometry in high-duty form.
Frequently asked questions
Why do tool motors lose power as they heat up?Partly the battery, partly the motor. If the magnet is under-specified for the temperature class, the rotor loses flux permanently as the tool warms, and the loss is cumulative.
Can I use a cheaper base grade in a low-duty tool?If the measured magnet temperature genuinely stays low, yes. The decision belongs to the measurement, not to the price list.
Does a stronger magnet make a tool more powerful?Not if the steel saturates or the magnet demagnetizes. Tool motors are usually limited by thermal and demagnetization margins, not by remanence.
What coating survives a wet site?Epoxy over nickel-copper-nickel where the design allows, with edge protection specified. For the wettest positions, consider whether the magnet can be relocated.
Developing a tool motor? Send the rotor drawing and the duty cycle and we will match the class to the measurement.