Magnetization direction decides where the field goes. It is the single most commonly mis-specified property on a magnet drawing, and the error is invisible until the part is in the assembly.
Why direction matters more than strength
A magnet's usable force depends on where its poles sit relative to the working face. The same disc magnetized through its faces, across its diameter or around its circumference gives three completely different fields. Grade changes the magnitude; direction changes the geometry.
Axial
Poles on opposite flat faces. Standard for holding, stacking and face-coupled circuits, and the default for discs, blocks and cylinders unless told otherwise.
Diametric
Poles across the diameter, so the field runs sideways through the part. Used where the field must sit across one axis, as in some sensing and torque arrangements.
Radial
Poles on the inner and outer surfaces, so the field runs outward or inward. Standard for rings, arcs and rotor segments where torque transfer or rotary sensing is involved.
Specifying it correctly
Mark the direction on the drawing with the pole faces identified, not just a note. For multi-pole parts, give the pole count and the pattern. If you are unsure, send the circuit requirement rather than a guess — the direction follows from the application, and a supplier can usually confirm it from the duty.
Frequently asked questions
What happens if the direction is wrong? The magnet will still attract, but the field will not sit where the circuit expects it, so performance collapses. The error is invisible until assembly.
Is axial the default? For discs, blocks and cylinders, yes — unless the drawing says otherwise. Rings and arcs are usually radial.
Can you supply multi-pole magnets? Yes. Pole count and pattern are set by the design and verified per lot.
How do I know which direction I need? Send the circuit requirement — which face or direction the field must act in — and we will confirm the direction from the duty.
If your question is not covered here, Request a quote and our engineering team will answer it directly.