A magnet drawing is the contract. Everything the supplier commits to is on it, and everything that is not on it is open to interpretation. The most common cause of a magnet project going wrong is not a manufacturing error; it is a drawing that was complete as a mechanical part and incomplete as a magnet.
Dimensions and tolerances
State the controlling dimensions, the datum they are measured from, and the tolerance on each. The industry default for sintered parts is around plus or minus one percent, and tolerances tighter than that need to be stated explicitly and priced explicitly. State which dimensions are functional and which are reference, because a supplier will hold the functional ones and treat the reference ones as information.
Material and grade
The grade should be stated with its full designation, including the temperature class suffix. "N42" and "42SH" are different materials, and a drawing that says only "NdFeB" has not specified anything a supplier can quote. Where the grade is not critical, state the property that is critical, such as a minimum flux or a minimum coercivity, and let the supplier choose the grade.
Coating and its thickness
State the coating system, not just "plated". Nickel-copper-nickel with a stated thickness range is a specification; "nickel" is not, because the thickness drives both corrosion performance and dimensional change. State any zones that must be free of coating, such as bonding faces or ground locating surfaces.
Magnetization direction
This is the item most often missing, and the most damaging. State the direction with an arrow, the pattern where it is not a simple two-pole part, the pole count, and the angular tolerance where it matters. For multipole parts, state the pattern as a drawing, not as words. A part magnetized the wrong way is not a defective part by dimensional inspection; it simply does not work, and it will not be caught until assembly.
Inspection requirements
State what will be measured and how: dimensions, flux or surface field, coating thickness, and any magnetic values with their tolerances. State the sampling plan, and state whether a lot record is required. For safety-related parts, state that 100 percent inspection is required rather than assuming it.
Acceptance criteria
State the chip and crack envelope: the maximum chip size and count, the exclusion zones, and the surface finish requirement. Without it, "chipped magnet" is a matter of opinion. This is the second most common source of disputes after magnetization direction.
The omissions that cause trouble
- No magnetization direction: the part works or does not, with nothing in between.
- No chip envelope: every chip becomes an argument.
- Grade without a class: the supplier guesses, and the guess is usually the cheaper one.
- Coating without a thickness: the supplier applies the thinnest acceptable layer.
- No datum: two people measure the same part two different ways.
- No marking requirement: polarity is unmarked and assembly becomes guesswork.
How to send a drawing for quotation
Send the assembly drawing as well as the part drawing, because the steel around the magnet changes the specification. Send the duty conditions: temperature, opposing field, environment and volume. And send your inspection expectation, so it can be priced rather than assumed. The sample approval article covers what happens after the quotation.
Frequently asked questions
Can you work from a sketch?For a quotation, yes. For production, no. A sketch starts the conversation; a controlled drawing ends it.
What if my drawing has no tolerances?We will apply the industry default and tell you we have done so. If your function needs something tighter, that is the moment to say it.
Should magnetization direction be on the part drawing?Yes, with an arrow, plus the pole pattern for anything multipole. It is the single most important line on a magnet drawing.
Do you review drawings before quoting?Always. We check the geometry against pressing and grinding capability and flag anything that will not hold, before the quotation rather than after the order.
Have a drawing you want reviewed? Send it over and we will tell you what is missing before you commit.