Speaker magnet sizing is a magnetic-gap problem. The magnet has to fill the gap with enough flux, and the material decides how much magnet that takes.
Start from the gap
A moving-coil driver is built around a magnetic gap: the space the voice coil moves in, between the pole piece and the top plate. The magnet's job is to fill that gap with flux. Size the gap first — it is set by the coil, the excursion and the power handling — and the magnet follows.
Then the flux density
The gap needs a certain flux density to reach the sensitivity and power handling the design targets. That density is a property of the magnet's working point and the circuit, not of the magnet alone — which is why a bigger magnet does not always mean a louder speaker.
Ferrite or NdFeB
Ferrite rings are the industry default: the lowest-cost material, no plating, tolerant of the heat a voice coil generates. Because ferrite carries roughly a quarter of NdFeB's energy per unit volume, the ring is physically larger — which is exactly why the classic speaker magnet is a big ceramic ring.
NdFeB rings deliver the same gap flux in a much smaller and lighter ring, at a higher material cost and with a coating requirement. They are the choice when size or mass is the constraint — compact drivers, headphones, weight-critical designs.
Ring dimensions and tolerances
Dimensional tolerances are confirmed against the approved drawing and depend on part size, geometry and finishing process. Please identify critical dimensions when requesting a quotation. Magnetization is axial through the faces, as the motor structure requires. Bonded versions are supplied for assemblies glued to the top plate.
What to send with the enquiry
Send the gap dimensions, the target flux density or sensitivity, the voice-coil power and the size or mass limit. With those the ring can be sized in ferrite or NdFeB, and the trade-off can be shown in numbers rather than adjectives.
Frequently asked questions
Why are speaker magnets usually ferrite? Cost, temperature behaviour and corrosion resistance. Ferrite delivers enough flux for a motor structure at a fraction of NdFeB cost, and the bare ceramic survives humid cabinets.
When is NdFeB better for a speaker? When size or mass is the constraint — compact drivers, headphones, weight-critical designs — because NdFeB delivers the same gap flux in a much smaller ring.
Does a bigger magnet always mean more output? No. Output depends on the gap flux density and the circuit, not on magnet size alone. A larger magnet in the same circuit may add little.
What tolerance can you hold on a speaker ring? Dimensional tolerances are confirmed against the approved drawing and depend on part size, geometry and finishing process. Please identify critical dimensions when requesting a quotation.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.