Pull force is the straight-line force needed to separate a magnet from a ferromagnetic surface, and it is the number printed on almost every magnet listing. What the listing rarely says is the conditions behind it: a thick, flat, clean steel plate, a full-face contact, and a perpendicular pull. Change any of those and the real number changes, often by a lot.
Where the force comes from
The force a magnet exerts on a steel surface comes from the flux density in the contact area and the energy stored in the gap between them. In simplified form, the force scales with the square of the flux density at the interface, which is why a grade with 20 percent more remanence does not give 20 percent more pull in a real assembly: the working point moves, the steel saturates, and the relationship is anything but linear.
The conditions behind a catalog number
- Steel thickness: the plate has to be thick enough not to saturate. A thin sheet behaves very differently from a block.
- Contact area: the full pole face touching, with no paint, no roughness and no gap.
- Direction: a straight perpendicular pull. Any tilt immediately introduces a peeling component, and magnets peel far more easily than they pull.
- Temperature: the figure is quoted at room temperature, and it falls as the magnet warms.
- Working point: the magnet is closed against the steel, which is close to the best case the magnet will ever see.
Shear force and safety factors
Slide the same magnet sideways and it holds only a fraction of its rated pull, typically a quarter to a fifth, because the force now works against friction rather than against the full magnetic attraction. Coatings, oil films and painted surfaces all reduce friction and therefore shear holding force further. For any real application, apply a safety factor on top: a design that relies on 90 percent of the catalog figure will fail in service, and a design that relies on 50 percent usually survives normal variation.
Why measured beats calculated
The honest way to quote pull force is to measure it, on a tensile tester, against a specified steel plate, with a specified direction. Calculated figures from finite-element analysis are useful for comparing geometries but they embed assumptions about the steel, the gap and the surface that rarely match the real assembly. When a supplier gives you a calculated figure, ask what was assumed; when a supplier gives you a measured figure, ask what it was measured against.
How to test it yourself
A simple bench test tells you most of what you need. Clamp a clean steel plate horizontally, place the magnet on it, and pull vertically with a spring scale or a hanging weight until it separates. Record the plate thickness, the surface condition and the direction. Do the same with a second magnet of the same grade and size and compare: variation between nominally identical parts is real, and it is the reason flux control matters more than a single pull reading.
Working with the number you have
Treat a catalog pull figure as a best case under ideal conditions. For a design, start from it, then derate for the gap, the surface, the direction and the temperature, and verify the result with a physical test before committing to production. The pull force versus breakaway force article covers the distinction between the two numbers, and the magnetic circuit article explains why the steel behind the magnet changes everything.
Frequently asked questions
Why is my measured pull lower than the catalog figure?Almost always the steel, the gap or the direction. A thin or painted plate, a slightly rough surface, or a tilted pull all reduce the figure below the ideal test.
Does a thicker coating reduce pull force?Yes, because the coating acts as an air gap. A thick epoxy layer can cost a noticeable fraction of the pull force compared with a thin plating.
Is pull force the same as holding force?For practical purposes yes, when the magnet is loaded perpendicular to the surface and in tension. In shear, or with a peeling load, the usable holding force is much lower.
Can you quote measured pull force for a custom part?Yes. We measure against a specified plate and report the value with the test conditions, so you know what the number means.
Need a pull force figure you can design against? Send the geometry and the mounting arrangement and we will measure rather than estimate.