Nickel and epoxy are the two coatings most NdFeB parts actually receive, and they solve different problems. Choosing between them is an environment decision.
What each coating is
Ni-Cu-Ni plating is a bright metallic finish: a nickel strike, a copper layer, then a nickel cap, typically 10–20 μm total. Per the YUECI KEJI surface-treatment datasheet it passes a 96-hour PCT and 48–72 hours of neutral salt spray.
Epoxy coating is an organic layer — black or coloured — typically 15–25 μm. It gives the best corrosion margin of the standard finishes and a non-reflective appearance.
Corrosion protection
Both protect bare NdFeB, which corrodes quickly, but they protect differently. Nickel is a barrier coat: it keeps moisture off the magnet until it is scratched. Epoxy is thicker and more forgiving of minor handling damage, and it tolerates salt mist better — which is why epoxy is the usual choice for marine, outdoor and handled duty.
Appearance and handling
Nickel is bright, reflective and conductive — useful where the part has to look like a machine component or make electrical contact. Epoxy is matte and non-reflective — useful where glare matters, in optical and medical builds, and where the part is handled by end users.
Cost and process
Nickel plating is the cheaper and faster finish and the easier one to inspect. Epoxy costs more, adds a curing step, and needs care at edges and holes where the layer can be thin. On high-volume indoor programs nickel usually wins on cost; on outdoor or handled programs epoxy wins on life.
The decision
- Nickel — indoor, clean, cost-first, appearance-driven duty.
- Epoxy — outdoor, marine, handled, glare-sensitive duty.
- Nickel plus epoxy — the most corrosive duty, where the plating gives the barrier and the epoxy gives the margin.
Frequently asked questions
Which coating lasts longer outdoors? Epoxy, in most outdoor and marine duty, because the thicker organic layer tolerates handling damage and salt mist better than a thin metallic barrier.
Is epoxy coating more expensive? Yes — it adds material, a curing step and edge-control care. The premium is usually worth it outdoors.
Can a magnet have both coatings? Yes. Nickel-copper-nickel under epoxy is specified for the most corrosive duty, combining the plating barrier with the epoxy margin.
Does the coating affect magnetic performance? No. Coatings are non-magnetic layers at the surface; they do not change the grade or the working flux.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.