Disc and block magnets do the same job with different geometry, and the choice between them comes down to pole area, machining and how the part is held.
What each shape is
A disc is a flat cylinder with two parallel faces — the workhorse shape for stacking, holding and flux-target work. A block is a rectangular prism with large flat pole faces — the most machinable shape and the cheapest route to a specific pole area.
Dimensional tolerances are confirmed against the approved drawing and depend on part size, geometry and finishing process. Please identify critical dimensions when requesting a quotation. The difference is geometric, not metallurgical.
Pole area and force
For a given volume, a disc and a block of similar dimensions deliver similar force — the pole area is what matters, and both shapes can be sized to any pole area the design needs. What differs is convenience: a disc is round, so it seats in a bore or against a curved surface naturally; a block gives the largest flat pole per unit of material and the easiest surface to drill, tap or bond.
Machining and fixturing
Blocks are easier to post-machine: drilling, grinding and tapping are routine, and a block can be held in a vise without special tooling. Discs need proper fixturing for any secondary operation, and thin discs are the more fragile of the two in handling.
Where each shape wins
- Disc wins when the part must be round — sensor targets, voice-coil stacks, shaft-end targets, anything that seats in a bore.
- Block wins when a large flat pole face has to meet a flat steel pole piece — holding fixtures, separators, motor pole pieces, custom machined sub-assemblies.
The practical answer
Choose the shape the assembly wants, not the shape with the better datasheet. If the magnet seats in a round pocket, use a disc. If it bolts to a flat plate, use a block. If both are possible, the block is usually the cheaper part to make and the easier one to modify later.
Frequently asked questions
Which shape gives more pull force for the same volume? Roughly the same — force follows pole area and grade, not shape. The block's advantage is that it delivers a large flat pole with less machining.
Are blocks easier to customize than discs? Yes. Blocks drill, grind and tap readily; discs need proper fixturing for secondary operations.
Can a block be magnetized multipole? Yes — multipole magnetization is routine for motor and separator duty, and the flat faces make the pole pattern easy to inspect.
Which is cheaper? For a similar pole area the block is usually the cheaper part to manufacture, because it needs less fixturing and less material removal.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.