Electric vehicle traction motors are the highest-profile use of sintered NdFeB, because they need maximum torque per kilogram and they run hot. That combination is exactly what drives the grade and temperature-class decision.
The traction motor is the main magnet load
A permanent-magnet traction motor converts battery power into torque through a rotor field, and NdFeB supplies that field at the highest energy per kilogram of any commercial material. Mass matters twice over in a vehicle: it is unsprung or rotating mass, and it is mass the battery must carry.
Why automotive duty pushes the grade up
A traction motor runs hot, and hot NdFeB loses output. Designers therefore reach for temperature-class grades — SH, UH and EH — or accept thermal derating. This is the classic automotive trade: energy product against coercivity against cost, with heavy rare-earth content as the price of the middle term.
The rest of the vehicle
Beyond the traction motor, magnets appear in auxiliary pumps and fans, seat and mirror actuators, wiper and window motors, sensors, latches and speakers. Most of these are small, high-volume parts where N35 to N42 grades are the economical default.
What automotive specification means in practice
Automotive buyers typically demand documented process control, lot traceability and change notification, because a material change can invalidate a validated motor design. YUECI KEJI operates under a quality system aligned with IATF16949 and ISO 9001/14001/45001 and reports magnetic results lot by lot.
Designing against magnet supply
Supply concentration in rare earths is a known automotive risk, so programmes increasingly ask about recovery and high-abundance material. Both are active areas of the company's technology programme and are worth raising at the design stage rather than after validation.
Frequently asked questions
Which temperature class does a traction motor need? It follows the measured hot-spot temperature at the magnet, not the average winding figure. Send the hot-spot and the acceptable flux loss and we will match the class.
Can you supply automotive-grade traceability? Yes. Lot identifiers and inspection records travel with each shipment, and material or process changes are notified before they take effect.
Are auxiliary motor magnets the same grade? Usually not. Auxiliaries run cooler and are cost-driven, so N35 to N42 in standard temperature classes is the common choice.
Do you support recycled or high-abundance material? Both are active programmes. Ask at the design stage so the formulation can be settled before validation.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.