A grade chart is the fastest way to shortlist a neodymium magnet. The table below covers the commercial range from N42 to N58, with the temperature series that follow it.
How to read the table
Four columns matter. Remanence (Br) is the flux the material can hold; intrinsic coercivity (Hcj) is its resistance to demagnetisation; maximum energy product (BH)max sets how much force you get per unit volume; and the maximum working temperature is the published ceiling at the reference geometry. Values below are the standard published ranges for the commercial grades.
Base grades N42 to N58
| Grade | Br (T) | Hcj (kA/m) | (BH)max (MGOe) | Max working temp. |
|---|---|---|---|---|
| N42 | 1.28–1.32 | ≥955 | 39–44 | 80 °C |
| N45 | 1.32–1.38 | ≥955 | 42–47 | 80 °C |
| N48 | 1.37–1.42 | ≥955 | 45–50 | 80 °C |
| N50 | 1.39–1.44 | ≥955 | 47–52 | 80 °C |
| N52 | 1.42–1.47 | ≥955 | 49–54 | 80 °C |
| N54 | 1.44–1.49 | ≥876 | 51–56 | 80 °C |
| N55 | 1.46–1.52 | ≥876 | 52–57 | 80 °C |
| N56 | 1.47–1.53 | ≥876 | 53–58 | 80 °C |
| N58 | 1.49–1.55 | ≥876 | 55–60 | 80 °C |
The temperature series
The same energy levels are also produced in temperature classes. M reaches 100 °C, H 120 °C, SH 150 °C, UH 180 °C, EH 200 °C and AH 230 °C, at progressively higher intrinsic coercivity. So 42SH and 52SH both carry SH-class coercivity at their respective energy levels.
Using the chart to shortlist
Start from the duty temperature to pick the class, then from the force or volume constraint to pick the energy level. If the part runs at ambient with margin and volume is available, a mid grade such as N42 or N48 is usually the economical answer. If volume is capped, move up the energy range.
What the chart does not tell you
Working temperature depends on the magnet's geometry as well as its grade, because a thin disc demagnetises more easily than a long one. The published figure is a reference value at a defined geometry, so confirm the real limit against your own L/D ratio and duty cycle.
Frequently asked questions
Is N58 always the best choice? No. Higher grades cost more and carry slightly lower coercivity at the top of the base range. If the design has volume margin, a mid grade is usually better value.
Why do N54 to N58 show lower coercivity? Pushing energy product higher trades against coercivity within the base series. For hot duty at those energy levels, a temperature class is specified instead.
What does the L/D ratio change? A longer magnet relative to its diameter works at a more favourable point and tolerates more heat. Thin discs lose output sooner, so the real ceiling is lower than the published figure.
Do you supply every grade in the chart? The commercial range from N42 to N58 is supplied in the temperature classes shown, to drawing or sample. Send the duty conditions and we will confirm the grade.
If your question is not covered here, Request a quote and our engineering team will answer it directly.