Applications

Magnets for Robotics and Automation: Encoders, Actuators and End Effectors | YUECI KEJI

Robotics and automation are precision applications: the magnet is usually part of a feedback or positioning loop, so its dimensional and magnetic stability matter as much as its force.

Robotics and automation are precision applications: the magnet is usually part of a feedback or positioning loop, so its dimensional and magnetic stability matter as much as its force.

Encoders and position feedback

Magnetic encoders pair a magnetised ring or disc with a sensor to report position. Here the requirement is uniformity and stability rather than raw force — the magnet must deliver a repeatable field, so grade consistency and tight tolerances matter more than a high energy product.

Joint and linear actuators

Robot joints use frameless or integrated permanent-magnet motors, and linear axes use voice-coil or solenoid-style drives. These are force-density applications where the magnet is designed into the motor, so the supplier works to the motor builder's drawing rather than to a catalogue part.

Grippers and magnetic end effectors

Magnetic grippers pick ferrous parts without mechanical contact, using a field that can be switched or released. They are magnetic-assembly products — magnet, steel pole and housing engineered as one unit with a defined holding force.

What to specify

Send the field or force target, the tolerance band, the operating temperature and the environment. For encoders, ask for measured magnetic uniformity across the ring rather than a grade alone.

Frequently asked questions

Which matters more for an encoder magnet, grade or tolerance? Tolerance and field uniformity. A high grade with poor consistency produces a noisy signal; a mid grade held tightly produces a clean one.

Can you supply magnetised rings for encoders? Yes. Rings and discs are supplied magnetised to the specified pole pattern, with the magnetic result verified per lot.

What about magnetic grippers? These are assemblies — magnet, pole pieces and housing engineered together with a defined holding force, verified unit by unit before dispatch.

Do you support prototype quantities? Yes, subject to tooling. Send the drawing and quantity and we will quote accordingly.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.