Medical devices use magnets in applications where failure is not acceptable and cleaning is aggressive. The selection criteria are therefore dominated by reliability, corrosion resistance and cleanability rather than by peak force.
Where magnets appear in medical equipment
Permanent magnets turn up in MRI-adjacent shim and positioning hardware, surgical power tools, infusion and dialysis pumps, patient-handling equipment, prosthetic retention and a wide range of diagnostic instruments. Most are small rotary or linear motors; the rest are holding and positioning applications.
The constraints that actually decide the choice
Devices are sterilised repeatedly — autoclave, chemical disinfectants or gamma — and must survive that without coating failure. They are also hand-held or patient-adjacent, so corrosion and particulate generation matter. NdFeB gives the force density; SmCo and ferrite trade force for corrosion resistance and temperature stability.
Material selection by duty
High-force, compact motors usually point to plated NdFeB with a robust coating. Aggressive chemistry or high temperature points to SmCo. Cost-sensitive, lower-force hardware points to ferrite. Where a magnet is implanted or in prolonged skin contact, material selection becomes a regulatory question for the device maker rather than a component choice.
What to specify
Send the sterilization method and cycle count, the operating temperature, the force or field target, and any biocompatibility or particulate requirement. YUECI KEJI supplies NdFeB, SmCo and ferrite to drawing with coating options selected against the cleaning regime, and reports each lot before dispatch.
Frequently asked questions
Which coating survives autoclave cycles? It depends on the cycle and the chemistry. Ni-Cu-Ni is the usual baseline; heavier barriers such as NiCuNi plus epoxy or a plated SmCo part are specified where the cleaning regime is aggressive. Tell us the sterilisation method and we will match the finish.
Is SmCo better for medical duty? Often, yes. It resists corrosion without plating and tolerates higher temperature, which suits repeated sterilisation. The trade is lower energy product per unit volume and a higher cost.
Can you supply implant-grade material? Implantable devices are a regulatory question for the device manufacturer. We supply the magnetic component to your material specification and support your qualification process.
Do you support small-batch medical orders? Yes, subject to tooling. Medical programmes often start small, so raise the volume forecast early and we will plan tooling accordingly.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.