Applications

Magnets for Magnetic Coupling: Torque Transfer Without a Seal | YUECI KEJI

A magnetic coupling transfers torque across a gap, which lets a driven shaft run behind a seal with no dynamic seal to leak. That single property is why the design is standard in sealed pumps, mixers and hazardous-duty drives.

A magnetic coupling transfers torque across a gap, which lets a driven shaft run behind a seal with no dynamic seal to leak. That single property is why the design is standard in sealed pumps, mixers and hazardous-duty drives.

How the coupling works

Two magnet assemblies face each other across a containment wall. The driver turns its assembly, the field crosses the gap, and the driven assembly follows. Torque capacity rises with magnet strength, pole count and coupling diameter, and falls sharply as the gap widens.

Where the design is used

Sealed pumps for corrosive or hazardous fluids, mixers and agitators, and drives where a dynamic seal would be a maintenance liability. The absence of a seal is the whole point, so reliability is the governing requirement.

What the magnet must deliver

High and stable torque, resistance to demagnetisation under the slip torque that occurs at start-up, and corrosion resistance on both sides of the wall. SmCo is common where the fluid is aggressive; high-temperature NdFeB classes are used where the duty is hot.

Specifying a coupling magnet set

Send the required torque, the slip torque, the gap, the operating temperature and the fluid environment. YUECI KEJI supplies matched inner and outer magnet assemblies to drawing, magnetised and verified before dispatch.

Frequently asked questions

NdFeB or SmCo for a coupling? NdFeB gives more torque per volume; SmCo gives temperature headroom and corrosion resistance without plating. Aggressive fluids usually decide it.

What happens at start-up slip? The driven side lags and the magnets work at a demanding operating point, which is why the slip torque and the demagnetisation margin have to be specified together.

Can you supply the full assembly? Yes. Inner and outer magnet sets are supplied as matched assemblies with polarity and torque verified.

How is corrosion handled on the wet side? Encapsulation, plating or a SmCo selection, depending on the fluid. Send the chemistry and temperature and we will recommend the combination.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.