Industrial motors are the workhorse application for permanent magnets: high volumes, established designs and a clear trade-off between force density and cost.
The motor families that use permanent magnets
AC and DC servomotors, stepper motors, brushless DC drives in fans and pumps, and a wide range of general-purpose industrial equipment. Each has an established magnetic circuit, so the magnet is usually designed to a known geometry.
Arc and segment rotors
Rotor magnets follow the curve of the stator, supplied as arcs or matched segment sets. Radial magnetisation is standard for torque transfer, and segment count and skew are set by the motor design.
Grade and temperature class selection
The hot-spot temperature sets the class; whether the design is force- or volume-limited sets the energy level. A motor with force margin often runs economically at N42 to N48, while a force-limited design pushes higher.
What to send when specifying
The rotor geometry, the back-EMF or torque target, the hot-spot temperature and the retention method. YUECI KEJI supplies arcs and segments in the N35 to N52 range with M, H and SH classes, reported lot by lot.
Frequently asked questions
Are rotor magnets supplied as segments? Either as single arcs or as matched segment sets, with count, skew and bonding gap agreed against your drawing.
Which way are they magnetised? Radially for torque transfer in most motors; other directions are possible where the circuit requires it.
How do you match a replacement set? Dimensions and magnetic results are recorded per lot, so replacements match the original set within the agreed tolerance.
Do you supply motor builders directly? Yes, to drawing or sample, with lot traceability and inspection records with each shipment.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.