Consumer electronics are the highest-volume, most cost-sensitive magnet market in the world. The parts are small, the tolerances are tight and the price target is unforgiving.
Acoustics
Speakers, receivers and earpieces use ring and disc magnets to set the field in the magnetic gap. NdFeB dominates because force per gram allows a thin, light driver; ferrite survives in the largest, cheapest designs.
Haptics and micro-actuators
Linear resonant actuators and vibration motors use small magnets in very high volumes. These are the most price-sensitive magnet parts in existence, so grade selection, coating and handling cost all compete with the magnetic requirement.
Latches, hinges and detection
Cover latches, hinge detents, Hall-effect triggers and tablet keyboard attachments all use small magnets, frequently with an adjacent sensor. Consistency across millions of parts matters more than the absolute force.
Wireless charging and attachment
Charging coils use magnet arrays for alignment, and magnetic accessory attachment uses ring and disc magnets sized for retention. Both need dimensional consistency across very large volumes.
What volume production demands
Tooling discipline, coating uniformity, packing that prevents chipping and lot-to-lot magnetic consistency. YUECI KEJI supplies these parts to drawing with per-lot inspection records and lot-by-lot traceability.
Frequently asked questions
Which coating is standard for a speaker magnet? Ni-Cu-Ni is the usual choice for corrosion resistance and adhesive bonding; black epoxy is used where the magnet is visible.
Can you supply magnet arrays for wireless charging? Yes. Ring and disc magnets are supplied as matched sets with polarity agreed against your coil design.
What quantities do you handle? From prototype through volume production. Share the forecast and we will plan tooling and capacity.
How consistent are lots at high volume? Magnetic results and dimensions are recorded per lot, and repeat orders are checked against the original record so the spread stays inside the agreed band.
If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.