PRACTICAL

How to Shield a Magnet: What Works and What Does Not | YUECI KEJI

You cannot block a magnetic field. You can only give it a better path than the one through your sensitive volume, and that distinction decides whether a shield works.

The most common question about magnetic shielding is how to block a magnet's field, and the honest answer is that you cannot. A magnetic field is a closed loop: it leaves the north pole and returns to the south pole no matter what you put in the way. What a shield does is offer a lower-reluctance path than the air inside your protected volume, so the field prefers to travel through the shield instead. Everything practical follows from that one idea.

What a shield is made of

Shielding materials are chosen for high magnetic permeability, which is the magnetic equivalent of electrical conductivity. Soft iron and low-carbon steel are inexpensive and work well against strong fields. Mu-metal, a nickel-iron alloy, has far higher permeability and is the choice for weak fields and precision instruments, but it saturates at lower field strengths and must not be worked or dropped after its final anneal. Ferrite does not shield static fields usefully; it is used for high-frequency interference, which is a different problem.

Why geometry beats material

A closed box shields far better than an open one, and a long tube shields its interior far better than a flat plate shields what is behind it, because the field lines that enter the open end have to travel the length of the tube to get out again. Gaps, seams and fastener holes all leak, and a seam parallel to the flux direction leaks less than one across it. The practical rule is that the shield's shape does most of the work and the material does the rest.

Why distance is the cheapest shield

A magnet's field falls off rapidly with distance, much faster than the inverse-square law for a small magnet because the field is a dipole. Doubling the distance from a small magnet can cut the field by a factor of eight or more. Before specifying a shield, check whether moving the sensitive component a few millimetres solves the problem. It usually does, and it costs nothing.

Practical shielding cases

  • Shipping: magnets are packed with steel keeper plates across the poles, which closes the field inside the package and also prevents slow self-demagnetization in storage.
  • Storage: horseshoe magnets and magnet sets are stored with keepers; bar magnets are stored in opposed pairs with unlike poles together.
  • Instruments: a mu-metal enclosure around a sensitive sensor, with the seam oriented along the flux, protects against stray fields from nearby motors.
  • Assemblies: a steel housing around a motor or actuator contains most of the stray field that would otherwise reach neighboring electronics.

What shielding cannot do

A shield does not reduce the field inside the magnet itself, and it does not make a strong magnet safe for a device that is genuinely field-sensitive at close range. If a pacemaker, a precision fluxgate or a magnetically encoded card has to sit within millimetres of a strong NdFeB magnet, the answer is to move the magnet, not to wrap the device. Shielding is a tool for managing stray fields at a distance, not for neutralizing a magnet at contact.

Frequently asked questions

Does aluminum foil shield a magnet?No. Aluminum is not ferromagnetic, and it does not provide a low-reluctance path for a static field. It shields radio-frequency interference, which is a different mechanism.

Will a thicker steel plate always shield better?Up to the point where it stops saturating. Past that, extra thickness adds weight without much benefit, and a better grade of steel or a closed geometry helps more.

Can I shield a magnet so it does not affect a sensor next to it?Partially. Enclose the sensor rather than the magnet where possible, because enclosing the source means containing a much larger total flux.

Do you supply shielding components?We supply keeper plates and steel-backed assemblies, and we advise on enclosure geometry. For mu-metal work we can recommend a specialist.

Need a shielding solution for an assembly? Send the layout and we will suggest the cheapest approach that works.