Guides

How to Choose a Magnetic Separator | YUECI KEJI

Magnetic separator choice is a flow problem before it is a magnet problem. The separator has to catch the contamination the line actually carries, at the rate the line actually runs.

Magnetic separator choice is a flow problem before it is a magnet problem. The separator has to catch the contamination the line actually carries, at the rate the line actually runs.

Start from the material

What is flowing, and how fast? Gravity-fed dry product, pneumatic conveying, pumped liquid and free-fall bulk each suit a different separator form. Grids for gravity chutes and pneumatic lines, plate and grate magnets for inclined chutes, liquid-line traps for pumped fluids, drum separators for high-volume free-fall material.

The form follows the flow, not the other way round.

Then the particle size and rate

The particle size to catch and the flow rate set the pitch and the tube spacing. A tight pitch catches finer contamination but restricts flow and needs more frequent cleaning; a wide pitch passes more material but misses fines. The trade is capture rate against flow rate, and it is set by the contamination spec, not by preference.

Then the magnet grade

NdFeB tubes deliver maximum pull at ambient temperature. Ferrite tubes are the choice where the line runs hot or the application is cost-first. Both are supplied to the same grid geometry, so the grade can be changed without redesigning the frame.

Grade matters less than people expect: once the field is adequate for the particle size, contact frequency — pitch — does more for capture rate than field strength.

Then the cleaning routine

A separator that is hard to clean does not get cleaned. Tubes should draw from the frame without tools where the line requires it, and the cleaning interval should be set by the contamination load rather than by convenience. Stainless tubes survive washdown and food duty; frames are painted or plated to the environment.

What to send with the enquiry

Send the material, the flow rate, the particle size to catch, the environment and the cleaning access available. The form, pitch, tube diameter and grade can then be quoted together against the duty.

Frequently asked questions

Which separator form should I use? It depends on the flow: grids for gravity chutes and pneumatic lines, plate and grate magnets for inclined chutes, liquid-line traps for pumped fluids, drum separators for high-volume free-fall material.

NdFeB or ferrite tubes? NdFeB for maximum pull at ambient temperature; ferrite where the line runs hot or the application is cost-first.

Does pitch matter more than grade? Usually, yes — once the field is adequate for the particle size, contact frequency does more for capture rate than field strength.

How often should a separator be cleaned? Set by the contamination load rather than convenience. A separator that is hard to clean does not get cleaned, so access is part of the specification.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.