Guides

How to Choose a Magnet Shape: A Practical Selection Guide | YUECI KEJI

Magnet shape is usually decided by the assembly, not by the datasheet. The useful question is not 'which shape is best' but 'what does the assembly force the magnet to be'.

Magnet shape is usually decided by the assembly, not by the datasheet. The useful question is not 'which shape is best' but 'what does the assembly force the magnet to be'.

Start from the mounting

The first question is how the magnet is fixed. Bonded or captured parts can be almost any shape. Screwed parts want a countersunk disc or a pot assembly. Shaft-mounted parts want a ring. Hung loads want a hook or clamp. The mounting usually eliminates half the catalogue.

Then the pole face

The second question is what the pole face has to meet. A flat steel pole piece wants a block; a round pocket wants a disc; a curved rotor surface wants an arc or segment; a bore that has to pass flux wants a ring. Match the pole face to the workpiece and the force follows.

Then the field direction

The third question is which way the field has to act. Through a face points to a disc, block or ring. Along an axis points to a rod or cylinder. Around a circumference points to a multipole ring or arc set. The magnetization direction is part of the shape decision, not an afterthought.

The shapes and their jobs

  • Disc — the default: stacking, holding, sensor targets, spacer positions.
  • Ring — shaft-mounted duty, encoders, couplings, anything that passes flux through the centre.
  • Block — large flat pole faces, holding fixtures, separators, custom machined parts.
  • Arc / segment — motor rotors, curved pole work, matched sets that build a ring.
  • Cylinder / rod — axial field with reach: sensors, probes, deep-bore assemblies.
  • Sphere — demonstration and direction-independent field.
  • Pot / cup / hook / clamp — assemblies that mount, hang or position a load.

When the shape is not enough

Sometimes no catalogue shape fits, and the answer is a custom geometry. Send the function — which face or direction the field must act in, what it must hold or sense, and the envelope — and the shape is proposed from the duty rather than guessed from a picture.

Frequently asked questions

What is the most common magnet shape? The disc. It is the default for stacking, holding and sensor work because it is the cheapest shape to make and the easiest to seat.

When should I use a ring instead of a disc? When the part mounts on a shaft or has to pass flux through the centre — and when multipole magnetization is needed, which only a ring can carry.

Is a custom shape expensive? It adds tooling, but the tooling is the main fixed cost and repeat orders are faster because it exists. Many custom geometries run from standard tooling.

How do I choose between an arc and a ring? Even pole count and simple pattern points to a ring; odd pole count, complex pattern or ring features point to matched arc segments.

If your application is covered here, Request a quote with the drawing or the duty conditions and we will confirm what is feasible.